0
  • DE
  • EN
  • FR
  • Internationale Datenbank und Galerie für Ingenieurbauwerke

Anzeige

Response Characteristics of Pre-Stressed Strand Cables Subjected to Low-Velocity Impact: Experiment Test

Autor(en): ORCID



Medium: Fachartikel
Sprache(n): Englisch
Veröffentlicht in: Buildings, , n. 2, v. 13
Seite(n): 330
DOI: 10.3390/buildings13020330
Abstrakt:

This paper introduces some experimental data measured from 63 impact tests of pre−stressed strand cables. The test specimens consist of seven steel wires that have a length equivalent to 100 times the outside diameter. To ensure consistency with the engineering service status, the strand cables are fully installed in a specially designed device and are axially pre−stretched to 0% to 40% of the ultimate bearing capacity before being subjected to lateral impact. The mass of the indenter is 50.34 kg, and the maximum impact velocity reaches 13 m/s. Two dimensionless variables, axial force and input kinetic energy, are used to control the experimental parameters. The recorded test data show that input energy and pre−stress level are the key factors governing the impact behavior, which is mainly characterized by plastic deformation controlled by the combination of tension and flexure, and the dynamic fracture concentrated in the impact zone is controlled by the joint effects of compression, tension and shear. As the impact energy increases, the dynamic mode of the test specimen changes from elastic rebound to plastic deformation, and finally evolves into fracture of some or all steel wires, which correspond to slight, partial and total loss of pre−tension, respectively. An increase in the level of pre−stress will significantly reduce the critical displacement of the structural failure but has little effect on the critical failure energy. The present paper provides a basic experimental data and mechanical analysis framework for the analysis, design and evaluation of the mechanical behavior of strands under accidental lateral impact.

Copyright: © 2023 by the authors; licensee MDPI, Basel, Switzerland.
Lizenz:

Dieses Werk wurde unter der Creative-Commons-Lizenz Namensnennung 4.0 International (CC-BY 4.0) veröffentlicht und darf unter den Lizenzbedinungen vervielfältigt, verbreitet, öffentlich zugänglich gemacht, sowie abgewandelt und bearbeitet werden. Dabei muss der Urheber bzw. Rechteinhaber genannt und die Lizenzbedingungen eingehalten werden.

  • Über diese
    Datenseite
  • Reference-ID
    10712390
  • Veröffentlicht am:
    21.03.2023
  • Geändert am:
    10.05.2023
 
Structurae kooperiert mit
International Association for Bridge and Structural Engineering (IABSE)
e-mosty Magazine
e-BrIM Magazine